Case Hardware Questions
How thick is the steel and what is the pin size? Thank you,
Mark
The steel is 1.5mm thick and the pin radius is R3.5.
Is the rubber hard/dense enough to support a dining table (one foot per leg)? We need to raise the table to accommodate different chairs and don't want them to compress over time. Thanks Neil
The F1615 we stock are within a Shore A hardness range of 65-75. The f1615 has a 70 shore A result
Can this product/extrusion be bought in longer lengths?
Good Morning,
We can supply E2280/2000 in lengths of up to 4 metres, however the cost of shipping for the longer lengths is higher. This is because the standard couriers will not deliver these lengths. If you require the longer lengths please add...
I looked at the website and found double angle extrusion made for 4mm thick panels. The Webstore only shows double angle extrusion for 1/4" and thicker panels. Is extrusion for thinner panels available?
If you take a look at all the double angle extrusion on our website:
https://penn-elcom.com/flight-case-hardware/extrusions/double-angle-extrusions
You can pick the most suitable model numbers and we can give you a price and availability.
Is the H1105/90 for a 1/2" radius cabinet edge ?
Yes the H1105/90 is suitable for a ½” radius
Did you find what you were looking for?
Categories:
Tags