wDALI-2 Bluetooth 5 wireless Bridge, with 20mA power supply. Module to wirelessly connect spatially separated DALI lines 89453348-PS

wDALI-2 Bluetooth 5 wireless Bridge with 20mA integrated Power Supply

Module
to wirelessly connect spatially separated DALI lines. The wireless
connection is bidirectional – control is possible from both DALI lines.
Additionally, DALI queries are supported.

The wireless connection
is set up using the DALI Cockpit PC Software. The device connected to
the DALI Cockpit can be set to Master mode and wirelessly searches for
all other modules (Slaves) within range. The Slaves can then be paired
with the Master via the Cockpit Software. After paring the DALI devices
in the Slave-DALI-lines can be addressed and configured wirelessly via
the wireless DALI bridge that has been set up.
The range of the wireless connection is up to 300m outdoors, inside buildings, depending on construction, from 10m to 20m.
The device is suitable for flush-mounted installation boxes.
Version without integrated DALI Power Supply LEDWDALI2BTBRG.

Product features:
Module for the easy connection of one or more spatially separated DALI systems
Bidirectional connection - allows control and queries of DALI devices of main and sub DALI lines bidirectionally
Configurable operating mode as master or slave
A master can be connected with multiple slaves, at maximum 10. This way multiple DALI sub-lines can be connected
Different
devices can be paired (max. 10 in total): BT Bridge in slave mode as
subline, wDALI-2 BT Dimmer: 1Ch, 2Ch, CWWW or wDALI-2 BT RM
Encrypted communication based on BT5 Long Range
Range of the wireless connection is up to 300m outdoors, inside buildings, depending on construction 10m to 20m are possible
Support of DALI-2 control commands
Easy configuration with the DALI Cockpit Software and DALI USB interface
This version comes with integrated bus power supply supplied by mains, provides a 20mA DALI bus power supply for the subnet (up to 10 DALI ballasts). If more power is required, the DALI sub-circuit can be extended with a DALI Expander LEDDALI2EXPDES.
2 sets of DALI terminals for easy connection - signal line can be looped through

Article number: 89453348-PS (version with 20mA power supply)
GTIN: 9010342014116

Input L, N
Input type: supply, mains-voltage
Marking terminals: L, N
Rated input voltage: 210-250 Vac
Input voltage frequency: 50-60 Hz
Environmental conditions:
Storing and transportation temperature: -20°C +75°C
Operational ambient temperature: -20°C +55°C
Rel. humidity, not condensing: 15% - 90%

General data:
Dimensions (l x w x h): 59 x 33 x 15mm
Protection class: SKII (when used/installed as intended)
Protection degree: IP20

Terminals:
Connection type: spring terminal connectors
Wire size: solid core: 0,5 - 1,5 mm2 (AWG20 - AWG16)
Wire size: fine wired: 0,5 - 1,5 mm2 (AWG20 - AWG16)
Wire size: using wire end ferrule: 0,25 - 1 mm2
Stripping length: 8,5 - 9,5 mm / 0,33 - 0,37 inch
Release of wire: push button

Standards:
DALI: EN 62386-101 /104 Dali+
EMV: EN 61547, EN 50015 / IEC CISPR15
Safety: EN 61347-2-11, EN 61347-1
Markings: UKCA, CE