Accessories

Dust protection cover for most speakON and powerCON chassis connectors to use when no cable connector is mated. Easy to use, it does not block the connectors in the panel below when not in use.

Dust protection cover for male chassis connectors to use when no cable connector is mated. Easy to use, it does not block the connectors in the panel below when not in use.

The handy dust protection cover for female chassis connectors can be used, when no cable connector is mated. The cover is easy to use and does not block the connectors in the panel below when not in use.

The dummyPLUG NDL for most Neutrik speakON and powerCON chassis enables you to simplify cabling.
Unused inputs can be covered to avoid miss wiring and protect against dust additionally.

The dummyPLUG NDM for Neutrik male XLR receptacles enable you to simplify cabling.
Unused inputs can be covered to avoid miss wiring and protect against dust additionally.

The dummyPLUG NDF for Neutrik female XLR receptacles enable you to simplify cabling.
Unused inputs can be covered to avoid miss wiring and protect against dust additionally.

Soft plastic cover for the rear end of several D-size chassis connectors. It is used to protect the gap between connector and cable.
The protection cover works with all common wires and cables - you simply cut off the cover end to the preferred diameter.

Fixing plate with M3 thread for efficient and easy mounting of all D-sized chassis connectors

Fixing plate with M3 thread for efficient and easy mounting of all G-sized chassis connectors

Double Bracket for Neutrik Connector

Gasket for speakON G-size housings for an airtight connection between chassis and frontpanel (also suitable for Amphenol EP cutouts).

Blanking Plug for XLR/Neutrik D-Series Connector cut-out.

Rear Mount Blanking and Converting Plugs for XLR/Neutrik D-Series Connector cut-out.

Front Mount Blanking and Converting Plugs for XLR/Neutrik D-Series Connector cut-out.

Cover plate to blank off XLR-hole.

Hinged cover for all D-size chassis connectors

This hinged cover seals D-size chassis connectors from water, dust and dirt in unmated condition according to IP42. It is available in different colours.

SCDX - black (if used with opticalCON, black indicates multi-mode)
SCDX-5 - green (if used with opticalCON, green indicates single-mode APC)
SCDX-6 - blue (if used with opticalCON, blue indicates single-mode PC)
SCDX-9 - white (e.g. wall outlet)

Coloured lettering plate for D-shape-connectors

Coloured boots for for NPC series Jacks + Neutricon

Bushings for colour coding.

Transparent coding ring which allows an individual customized labeling, branding, coding etc.


Just place an individual coloured and or lettered paper or tape (eg. Brothers) inside the ring.

Coloured coding rings.

Insert must not be unsoldered to change the colour coding.

Coloured rings with flat label surface for PX-Series.

Faston Receptacle for Speakon Chassis

Faston receptacle with Positive lock for use with NL4MP, NL4MPR, NL8MPR
Wire size: 0.8 - 2 mm
Wiring: flat tabs for 3/16in (FASTON 4.8 x 0.5 mm)

Bag quantity = 100

Coloured boots for PX-Series.